Resources

- About LINK
- Contact
- LINK's Links

System 1100 Tonnage Monitor

The System 1100 is a microprocessor-based monitor that can determine, display and compare developed forces with preset limits for machines that use large forces in the production process. Utilizing strain gage transducers located on appropriate load bearing machine components, the System 1100 is able to measure and display both total load and load distribution.  The measured forces are compared with adjustable high, low, and reverse setpoint limits for each strain gage transducer channel.  An out-of-limit stroke will trip an alarm circuit that sends a stop signal to the machine control. 
 

• Protect Machines
• Protect Dies
• Assess Tooling Wear
• Control Part Quality
• Conserve Energy
• Meet OSHA Requirements
• Analyze Tooling Signatures

Features and Benefits

  Available in either 2 or 4 channels 
  Use of Data Windows allow for close monitoring by not only checking absolute peak tonnages, but also checking up to 4 additional local peaks created by staggered tooling 
  Automatic setup allows all setpoints to be calculated and set automatically 
  123 setups can be stored and recalled by job name or number

System 1100 Specifications
SIZE:		14" wide x 7" high x 6" deep
INPUT POWER:		115 VAC +/- 15VAC, 1 ampere
OUTPUT RELAY CONTACTS:		5 AMPS @ 120VAC Normally Open energized closed (opens on fault)
DISPLAYS:		One four-digit LED display for the total peak tonnage and one four-digit LED display for each channel peak tonnage. One ten segment multi-color bar graph LED display for each channel. One 2 line by 20 character alpha-numeric LCD display.
INSTRUMENT ACCURACY:		+/- 0.1% of full scale
ALARM REPEATABILITY:		0.1% of full scale
GAIN RANGE:		500 to 10,000
RECORDER OUTPUTS:		10 Volts, full scale
SPEED:		0-2000 SPM
RESPONSE TIME:		less than 15 milliseconds
SERIAL PORT:		RS-232, 19.2 kbaud

444 McNally Dr. Nashville, TN 37211 - Phone 888-342-1783 Fax 615-834-1984 - Copyright © 2011